Anchor the sleeved ends of your lines to something sturdy and unwind them fully. Note any difference in length between the lines.
Welcome, and congratulations on your selection of a new Bora Parafoil - we hope you'll love it as much as we do! In this guide we've put together all the info, tips, and tricks you'll need to get the most out of your new kite: From assembly and launching instructions to maintenance and customer support, we've got you covered! Read through to get the full story on your new kite, or use the table of contents to jump straight to a specific topic.
Not finding the answers you need? Contact our team and we'll get back to you ASAP. We look forward to making your flight a success!
Smooth winds,
The Prism Team
As a pilot, you - and only you - are responsible for your safety and the safety of those around you when you fly. Read these instructions thoroughly, and make sure you understand how to properly use your kite before launching.
Make sure your flying space is clear before launching. Kites can move quickly and unpredictably, and your kite or its line could seriously injure anyone in their path if something goes wrong.
Never wrap your flying line around your hands. In a gust, the wind can cause your kite to pull hard enough for the line to cut you seriously. Always hold the line by its winder or appropriate handle.
IMPORTANT: The flying lines that come with your kite require proper care and handling to ensure their longevity. Used correctly your lines will last many years, but if mishandled you'll risk breaks, tangles, and even the loss of your kite. We've outlined the most common issues flyers encounter with their lines below, along with information to help you avoid making these mistakes yourself. Replacement flying lines are not covered under your kite's warranty, so be sure you read and understand the information in this section before you start flying.
The included lines are sufficiently strong to support your kite when flown within the advertised wind range (5-25 mph), but if those speeds are exceeded your lines may break. To prevent this, avoid launching your kite in winds near the very top of the recommended range. Wind speeds are variable, and flying at the maximum wind speed will leave you vulnerable to breakage if conditions suddenly change or an unexpected gust of wind comes along. Wind speeds are also generally stronger higher up in the air, so if you notice ground level speeds near the upper limit it's best to wait until conditions calm a bit before launching.
Breaks can also occur when attempting to tug your kite free of something it's become tangled in. Stay away from trees and other obstacles to avoid getting stuck, and if you experience an unplanned landing, check to be sure your lines aren't caught on anything before re-launching.
Lastly, keep a safe distance from other kites when flying. Lines can cut through each other when they get tangled in flight, so leave enough space for your neighboring kite flyers when choosing a spot to fly.
Tangles and knots can be hard to fix, but luckily they're also very easy to prevent. Just remember this - your flying lines should always be either completely wound onto the included winder, or they should be making a straight line from the wrist straps to the kite. Avoid dragging your flying lines on the ground, unwinding them into a pile at your feet, or taking 'shortcuts' when winding them up at the end of your flight session, otherwise you're likely to end up with a tangled mess as your reward.
We've designed the Quantum's bridle with color-coded pigtails to make connecting your lines as simple as possible. Just clip the end of your flying lines onto the matching pigtails and you're ready to go! If you prefer, you can also remove the clips and attach your lines directly to the bridle using the more traditional Lark's Head knot method (see Useful Knots).
Flying line connected to bridle with attachment clip
Flying line connected directly to bridle with Lark's Head knot
When you're done flying for the day it's important to properly store your flying lines back on their winder, ensuring your lines are ready-to-use and tangle free when you start your next flying session. Here's our preferred winding method:
Hook the colored cords from both wrist straps through the slot in your winder to anchor your lines in place.
Holding both flying lines together, wrap them onto the winder in a figure-8 pattern, continuing until all the line is on the winder (single line shown for simplicity).
Once the lines are fully wrapped, fold the wrist straps over the wound lines. Pull the elastic cord around the winder and slip the knot into the notch on the winder’s handle to secure.
Your new lines will stretch as you use them - don't worry, this is normal! The adjustable wrist straps that came with your lines can be used to quickly even them out as you break them in over time. Here's how to make this adjustment:
Anchor the sleeved ends of your lines to something sturdy and unwind them fully. Note any difference in length between the lines.
Pull the knot out from inside the wrist strap on the longer line, and slide the wrist strap forward to access the adjustment pigtail.
Tie an overhand knot in the pigtail. The distance between the new knot and the old knot should be equal to the difference in length between the two lines. Slide the wrist strap back into position, seating the knot inside.
Confirm that the lines are now even (within a half inch), and reposition the knot if necessary.
Double Overhand Loop
Used to finish the end of your flying line. Works well for both sleeved and un-sleeved lines.
Blood Knot
Can be used to join two pieces of line if your flying line breaks.
Lark's Head Knot
Can be used to connect your flying line to the line attachment point on your kite's bridle without the aid of an attachment clip.
If you're new to dual-line flight we recommend getting started on a day with wind speeds between 8-12 mph to ensure you have enough wind to easily launch your kite, but not so much wind that your kite is difficult to control. Be prepared to crash a few times as you get the hang of things - "unexpected landings" are a perfectly normal rite of passage for new flyers, so don't be discouraged! Read through this entire section before you get started so you'll know what to expect.
The term wind window is used to describe the space around you in which it is possible to fly your kite. This space extends overhead, downwind, and to the left and right of your location on the flying field, creating a 1/2 dome around you as shown in the accompanying illustration.
Directly downwind, in the center of the wind window, is the power zone (shown in red). This is the easiest place from which to launch your kite, and once airborne this is where your kite will develop the most speed and pull. As you steer your kite toward the edges of the window, you'll notice it will start to slow down and will pull less strongly.
Lay your kite on its back, pointing away from the wind. If the wind wants to blow it away, you can keep it in place by scooping some sand or small, smooth rocks along the trailing edge of the kite. With your kite in position, attach your flying lines and unwind them from the winder as you slowly walk into the wind, laying the lines out in a straight line on the ground behind you. When you reach the end of your lines, stash the winder in your pocket and hold the wrist straps in each hand (red on right, blue on left). Although not strictly necessary, it can be helpful to untwist the two lines before launching by passing the wrist straps from hand to hand a few times.
Stand in a relaxed position facing your kite, with your hands in front of you but not fully extended. Keep your arms relaxed, and focus on maintaining this position as you fly. Keeping your hands in front of you ensures you'll always have room to move your hands in order to control the kite.
Gently pull the lines toward you evenly, raising your kite into an upright and slightly nose-back position. Anything you placed on the sail to keep it in place will slide off, freeing your kite for take-off. Check to be sure that your kite and lines are not being snagged by anything on the ground.
Keeping the kite in position, fully extend your arms in front of you at about shoulder height. In one rapid motion, take a step backwards and sweep your arms sharply downward and back alongside your hips. Your kite will leap from the ground and begin flying upward. Once the kite is moving, keep your hands together and at the same distance from your chest and let it fly straight up. Wait until the kite is fairly high in the sky before trying a turn. This will give you more space and time to react before you get too close to the ground.
Your kite will fly straight in the direction its nose is pointed as long as you hold the wrist straps evenly at the same distance from your chest. It will turn as soon as you pull one of the wrist straps so that your hands are no longer even. The kite will continue to turn as long as you hold your hands offset. The more you offset your hands, the faster and tighter the turn will be.
To make a right (clockwise) turn, gently pull your right hand 4-6 inches toward your chest. Remember that as long as you hold your right hand close to you, the kite will continue to turn clockwise and will even complete a loop if held long enough. Any time you return the controls to an even position, the kite will fly straight in the direction its nose is pointed.
To turn left (counter-clockwise) make a gentle pull with the left hand. Some people find it helpful to steer by imagining that the control handles are the handlebars of a bicycle, and that pulling one handle will cause the kite to turn in the same way that pulling one handlebar will turn a bicycle.
Once you have a comfortable amount of altitude, begin to experiment with turns. Keep your control motions small at first (4"-6"), and keep the kite generally in front of you, not too far left or right. After a little practice you should be able to fly the kite back and forth in a sweeping motion by alternately pulling on your left and right lines.
As you gain control and confidence, you may want to try some refinements. Practice making each sweep straight and horizontal. Plan the timing and size of each turn and try to stick to it. Expand your sweeps to the left and right to explore the edges of your flying space.
When you get the courage to attempt a loop, afterwards you'll find that your lines have become twisted together - this is completely normal! Your flying lines are made from a special material that allows them to slide past each other even twisted several times, and the controls will not be affected. Keep track of how many loops you've completed, and perform an equal number of loops in the opposite direction to untwist your lines.
TIP: Once you've learned to untwist your lines in-flight, you can skip that step when setting up your kite. Just launch with the lines twisted together and do a few spins once you're airborne to separate them.
If you haven't already "accidentally landed" your kite and you're ready to end your first flight session, try this: Turn your kite gently toward the left or right, and fly it all the way off to one side of the wind window. As you near the extreme left or right, the angle at which the kite meets the wind will cause it to lose its lift, and the kite will begin to slowly settle to the ground. Keep your hands steady and make small adjustments to guide your kite to a gentle landing.
In 1996 we released our first comprehensive training video, Way to Fly, and it's still a great resource for new flyers to learn from almost 30 years later. While the kites shown in the videos are no longer available, the concepts and skills discussed in the training are still relevant today. Start with Way to Fly: Part 1 to get a good handle on setup, basic flying controls, and core concepts, then move on to The Advanced Way to Fly once you've mastered the basics and you're ready to take on more challenging tricks and maneuvers.
Freestyle Pilot is an organized, step-by-step training program designed to guide you from your first basic landings to the most challenging freestyle tricks being done today. Includes many new, more challenging maneuvers that were developed after the release of our original Way to Fly series.
1 - Tail
2 - Air inlets
3 - Bridle
4 - Flying-line attachment point